[Guide] Dahua XVR 4.0 Online p2p Setup

  This article will show you how to setup Dahua XVR 4.0 remotely using P2P on your mobile.

Configuring P2P Settings

You can add the Device into your cell phone client or the platform to manage.

You can also configure P2P function by selecting

Main Menu > NETWORK > P2P.

Make sure the DVR is connected into the Internet, and if yes, in the Status box of the P2Pinterface, it shows Online.

After you have configured the network settings, on the NETWORK interface, click

Step 1

Next.The P2P interface is displayed.

Step 2

Enable the P2P function.

After the P2P function is enabled and connected to the Internet, the system will collects your informationfor remote access, and the information includesbut not limited to emailaddress, MAC address, and device serial number.

You can start adding the device.

• Cell Phone Client: Use your mobilephone to scan the QR code to add the device into the Cell Phone Client, and then you can start accessing the Device.
• Platform: Obtain the Device SN by scanning the QR code. Go to the P2P management platformand add the Device SN into the platform. Then you can access and manage the device in the WAN. For details, please refer tothe P2P operation manual.

You can also enter the QR code of Cell Phone Client and Device SN by clicking on the top right of the interfaces after you have entered the Main Menu.

To use this function, take adding device into Cell Phone Client as an example.

Adding Device into Cell Phone Client

Use your cell phone to scan the QR code under Cell Phone Client to download the

Step 1 application.On your cell phone, open the application, and then tap.

Step 2 The menu is displayed. You can start adding the device.Tap Device Manager.1)The Device Manager interfaces displayed.

Click + on the top right corner.

The interface requiring device initialization is displayed. A pop-up message reminding you to make sure the Device is initialized is displayed.

3.) Tap OK.

• If the Device has not been initialized, Tap Device Initializationto perform initializing by following the onscreen instructions.
• If the Device has been initialized, you can start adding it directly.

4.) Tap Add Device.The Add Device interface is displayed.

You can add wireless device or wired device. The Manual takes adding wired device as an example.

5.) Tap P2P.

The P2P interface is displayed.

6.) Enter a name for the DVR, the username and password, scan the QR code under Device SN.

7.) Tap Start Live Preview

The Device is added and displayed on the live view interface of the cell phone.